Complete Dayton 1/7 HP AC-DC Series Motor With Power Supply, Controller & Timer

Description

Complete Dayton 1/7 HP AC-DC Series Motor With Power Supply, Controller & Timer. The output shaft is about 0.310 inches in diameter with one flat.
This is ready to be plugged into a standard 120v ac plug (carefully of course) and run. All wiring is connected as it should be.
There is a panel mount on/off power switch and fuse on the power cord. The main switch on the controller is a two position plus momentary down to activate the timer. Push this switch up for constant on or down to activate a timed cycle of a length set by the timer knob. A timer cycle can be aborted by turning the switch to the on position then to off.
The speed control will run it with no load from 0 RPM to a little over 10K I think but there is a trim adjustment under that knob on the control board you can set after it’s installed.
The timer currently runs it anywhere from 0 seconds to about 70 seconds. If you need a longer max time per cycle I can remove the small brown and blue 10 mfd capacitor and solder in a larger one which can yield up to probably 20 minutes at the top of the timing range. Or about anywhere in between. We may even be able to stretch it higher but I would need to experiment a bit. Please request this before making your purchase.
Free Priority Mail Shipping puts this in your hands in just a few days!